Spray contact WD-40 Specialist 250ml

WD-40 Specialist Contact Spray cleans oil, soot, flux residue and condensation from sensitive electronics and electrical equipment.

It penetrates quickly into hard-to-reach areas, and dries quickly without leaving residue.

Recommended for printed circuit boards, electrical components, printers and switches.

Hazard statements:

H222, cat. 1: Extremely flammable aerosol.

H225, cat. 2: Highly flammable liquid and vapour.

H229, cat. 1: Pressurized container: may burst if heated.

H304, cat. 1: May be fatal if swallowed and enters respiratory tract.

H315, cat. 2: Causes skin irritation.

H319, cat. 2: Causes serious eye irritation.

H336, cat. 3: May cause drowsiness or dizziness.

H411, cat. 2: Toxic to aquatic organisms with long lasting effects.

Precautionary statements:

P101: If medical advice is needed, have this container or label at hand.

P102: Keep out of the reach of children.

P210: Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. Do not smoke.

P211: Do not spray on an open flame or other ignition source.

P251: Do not pierce or burn, even after use.

P261: Avoid breathing dust/fume/gas/mist/vapour/spray.

P273: Avoid release to the environment.

P280: Wear protective gloves/protective clothing/eye protection/face protection/hearing protection.

P305+P351+P338: IF IN EYES: Rinse cautiously with water for several minutes. remove contact lenses, if possible; keep rinsing.

P312: Call a POISON CENTER/doctor if you feel unwell.

P405: Store locked up.

P410+P412: Protect from sunlight. Do not expose to temperatures above 50°C.

P501: Dispose of contents/packaging in accordance with the applicable legal regulations regarding waste disposal.